|
All residents are expected to familiarize themselves with and abide by these rules |
G. Moving a Manufactured Home into the Community
1. Any Manufactured Home (“Home”) moving into the Community must be approved by the Community Owner or Management.
2. For consistency and overall Community appearance, only Manufactured Homes built after 1990 and meeting either CSA-Z240 or CSA-A277 standards, or built in accordance with the BC Building Code, will be allowed to move into the Community. They also must have an asphalt roof and vinyl siding or materials of a similar quality and appearance.
3. Home must be moved into the Community by professional movers. The cost of moving and set-up with service connections, such as gas, sewer, water and electricity is the responsibility of the Resident. Where water pressure is above 60 p.s.i., this "set-up" must include a water pressure-reducing valve, which either conforms to municipal standards or is approved in writing by the Manager. Home must also be fitted with a suitable water back-flow prevention device.
4. Home must be set on the Homesite as low as possible. In any event, the maximum allowable distance from the blacktop or ground level to the top of the Home frame is 30” inches.
5. Resident must remove all hitches on the Home and install skirting acceptable to the Manager within thirty (30) days of occupancy. Homes shall not be permanently attached to the foundation. Stabilizing devices, piers, blocking or other type of support acceptable to the Manager may be used. Tie-downs are recommended, but not mandatory.
6. Resident must install permanent stairs and landing with aluminum or vinyl covered wood railings at the front or side of the Home within thirty (30) days of occupancy. The maximum extrusion from the Home is 4 ft. (122 cm), with a maximum stair width of 4 ft. (122 cm).
7. Within thirty (30) days of occupancy, Resident must install aluminum or vinyl eaves troughs, including down spouts, and connect the down spouts to proper ground drainage as instructed by the Community Manager.
8. Awnings or patio covers, if installed at any time during occupancy, must be approved by Community Management and must be constructed of aluminum materials.
9. Resident must affix his lot number to the front of his or her Home in 4-6 inch high numbers. Such numbers must be in a contrasting and complimentary colour to the Home colour.
10. Manufactured Home moving companies must present liability insurance documents to the Manager before approval to move the home into the Community is granted.
|
Don't Forget...
These community rules are in effect 24 hours a day, all 7 days of the week, all year round. No exceptions!
|
|